OpenServo.com Forum Index OpenServo.com
Discussion of the OpenServo project
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Recommend EMF proof servo

 
Post new topic   Reply to topic    OpenServo.com Forum Index -> Hardware
View previous topic :: View next topic  
Author Message
kenw232



Joined: 10 May 2013
Posts: 1

PostPosted: Fri May 10, 2013 5:36 am    Post subject: Recommend EMF proof servo Reply with quote

I'm working with the Hitec HS-422. It works fine until there is some EMI in the room from a high voltage coil I got. It starts bouncing around like a fish out of water. It's definitely the servo as I disconnected the controller and everything else and only applied 5V to it and it will bounce around as soon as I turn on my high voltage coil which is in the next room almost.

Can anyone recommend a servo that is not hypersensitive to EMI? I'm working with the Phidgets libraries and hope to find something compatible with that.

Thanks for any help.
Back to top
View user's profile Send private message
Wrirdonoki



Joined: 18 Feb 2015
Posts: 2

PostPosted: Wed Feb 18, 2015 4:34 am    Post subject: D Reply with quote

Oh I could not find something that's too long for it.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OpenServo.com Forum Index -> Hardware All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group