OpenServo.com Forum Index OpenServo.com
Discussion of the OpenServo project
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Board for HS-5646WP ?

 
Post new topic   Reply to topic    OpenServo.com Forum Index -> Hardware
View previous topic :: View next topic  
Author Message
Knaldgas



Joined: 10 May 2013
Posts: 1
Location: Denmark
PostPosted: Fri May 10, 2013 10:27 am    Post subject: Board for HS-5646WP ? Reply with quote
Hi

I would like to modify a bunch of HiTec HS-5646WP servos with an OpenServo board.

For this project I would like:
1) A design that "just works".
2) I2C interface.
3) Current or Power feedback.
4) Position feedback.
5) No electrolyte capacitors.
6) Max measures 16.5mm x 16.2mm

Which version would fit this list best?
I'm willing to redesign the PCB if necessary, even though I would prefer an already complete design Smile

Are there any issues with integrating into such a servo that I should be aware of? Position-pot values, or...?

~Knaldgas
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OpenServo.com Forum Index -> Hardware All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group